![]() Reason i think this, is because when i rev the engine the temperature swings. I believe it has to do with a voltage that is interfering with the coolant sensor. I have no idea what is causing it, i have screwed with the wastegate settings with no solution. This causes the fan to kick in unnecessarily which cools the oil and coolant below the setpoint. What happens is the coolant sensor gets a false reading and hits maximum temperature ( in my case 205C ). Without the Procede installed the temperature is way more calm without the fluctuations. I have the BMW electric wheel and my coolant temp is bouncing around by 3-5 degrees all the time when i have the Procede installed. I have had the same issue and its absolutely a Procede issue. Then I have to pull over off the freeway just to restart the car, pretty scary but I'll try adjusting the wastegate comp and see what happens Thanks for the info, for me the issue only occurs when I'm on the freeway maintaining around the same rpms for a long period of time, then when I go to get on it to blip the throttle to downshift, the revs don't shoot up as they should and that's when I look as see my engine temps way lower than they were. I'd take it to the dealership, even if they don't change it, they'll give you an explanation as to why the problem is occurring. It appears that you're still under warranty and its only like a $15 part even if you weren't and I think it's pretty easy to change. Now with the Procede uninstalled, my car does not throw the code and the fan functions normally but I still have power loss. Once I start the car, the radiator fan sounds like a jet turbine and it does not stop running.įrom what the Bentley manual states, with a bad ECT sensor, the car runs but assumes worse case scenarios for the coolant temps and restricts aggressive timing levels or afrs hence the possibility for reduced performance. ![]() ![]() ![]() I have a buzzing from the front of the engine bay with the car on accessories mode but not started. My symptoms are 12000 code(2ee0 - Engine coolant temp sensor) and extreme power loss, slower than stock. I am getting the same issue but only with the procede installed. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |